Fromm P359, Руководство по эксплуатации, Страница: 15 / 16

P380 Pneumatic Strapping Tool Operation Manual | FPA001 | Apr 2018 | Page 13
Tool Trouble Possibilities Solution
Welding m
otor doesn’t
run
Welding motor defective Check component parts and
replace damaged ones
Welding mechanism
defective Check component parts and
replace damaged ones
Pneumatic control system
is defective Check component parts and
replace damaged ones
Gear noise Tensioning or welding gear
is worn Check component parts and
replace damaged ones
Welding motor does not
stop Turn off valve or welding
motor valve jam, resp. the
welding time valve is
blocked Check and clean parts,
exchange damaged parts
Diameter of the air supply
hose is too small Install air supply hose with a
minimum inner diameter of
10mm
Not enough air volume Take care that there is
enough air volume
Tool badly cuts the strap
or doesn’t cut at all Cutter is worn or damaged Replace cutter
Welding gripper is worn Replace welding gripper
Welding time too short Change adjustment
(See 3.3.2)
Welding time not
adjustable Welding time valve dirty or
damaged Clean and check
component parts and
replace damaged ones
Tensioning force not
adjustable Tension force control valve
dirty or damaged Clean and check
component parts and
replace damaged ones