Fromm P326.0001.01, Руководство пользователя

Страница: 8 / 56

1-6
1.4 PERIODIC MAINTENANCE AND CONTROL
(Carry out 12- months cycles doing one shift work. Doing more shift work respectively more often.)
1.4.1 Procedure
Before using check tool for following possible faults:
• Visual test of the tool for loose, lost or damaged parts
• Clean all dirty parts of the tool, especially strap abrasion in the tensioning or the welding unit by
using compressed air. (Never use any hard tools like a wire brush or a screw driver for cleaning)
Carry out a test strapping and check following:
• Insertion of the strap
• Strap feed and strap tensioning
• Tensioning force adjustment (see operation manual P326)
• Cutting of the upper strap
• Welding time adjustment (see operation manual P326)
• Seal quality (see operation manual P326)
• Function of the LED - display
Proceed according to paragraph 1.4.2 after a fault appears.
Attention!
Remove battery from tool before each maintenance work.
For exchange of wearing parts see operation Manual P326.
Never use water or solvents for cleaning the tool’s surface.