8-11
P325mane.fm
Removing the empty battery
If the red LED starts lighting while a tensioning or welding procedure, the capacity of the battery is exhausted.
All electric functions of the tool are blocked.
The seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be removed from the package!
The battery must be recharged.
Push the unlatching push buttons at both sides of the battery.
Push the battery out of the tool in the opposite direction of insertion.
When removing the battery the LED lights shortly red.
6.2
Adjustments
6.2.1 Preselecting of strap tension and tensioning speed
Do not adjust the tensioning force too high.
If the tensioning force is higher than the tensioning strength of the strap,
the strap will tear while the tensioning.
Tensioning force and tensioning speed can be preselected
with the upper adjusting knob.
Turning clockwise increases;
turning counter clockwise decreases the tensioning force
and the tensioning speed resp..
The tensioning force on the minimum setting is 600 N
(135 lbs) and it is increased on the maximum setting to
3500 N (787 lbs).
The tensioning speed on the minimum setting is 100 mm/s
(3.9 inch/sec), it is increased on the middle setting to
130 mm/s (5 inch/sec) and remains on this value till the
maximum setting.
6.2.2 Adjusting the welding time
Depending on the size and quality of the strap, different
welding times are required.
The welding time can be adjusted at the lower adjusting
knob.
Turning clockwise increases,
turning counter clockwise decreases the welding time.
Adjusting knob tensioning force /
tensioning speed
Adjusting knob
welding time
