FROMM
FS4.1333-Manual-32.11XX.XXX.V04-EN08_R2.doc
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2017
website: www.fromm-stretch.com
24
INSTALLATION INSTRUCTION
ATTENTION!
All mentioned activities may only be executed under supervision of qualified personnel from the
manufacturer or his representatives!
FOR EVERYTHING IS VALID: IF APPLIED!
Due to shipping requirements, the shaft (1) is usually shipped horizontally and bears on a
support that has been specifically set up for it. Consequently the shaft must be re-positioned
when the machine is installed.
-
Upon having located the machine, lift the shaft (
1
) by turning it around the fulcrum shaft that has
been specifically setup and then locate the shaft upright as compared to the turntable
-
Secure the shaft vertically to the relative plate with the
11
screws (Figure 2 & 3)
-
Tighten the two stabilizing screws (
2
) (Figure 4 & 5)
-
Place the motor cabinet over the motor and secure with screws (Figure 6)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
