It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2003
FROMM
FS 270 series
INSTALLATION INSTRUCTION
ATTENTION!
All mentioned activities may only be executed under supervision of qualified personnel from the
manufacturer or his representatives!
FOR EVERYTHING IS VALID: IF APPLIED!
Due to shipping requirements, the shaft (1) is usually shipped horizontally and bears on a
support that has been specifically set up for it. Consequently the shaft must be re-positioned
when the machine is installed.
- upon having located the machine, lift the shaft (
1
) by turning it around the fulcrum shaft that has been
specifically setup and then locate the shaft upright as compared to the turnplate
- secure the shaft vertically to the relative plate with the three screws (
3
) (Figure 2)
-
tighten the two stabilizing screws (
4
) (Figure 2)
- Place the motor cabinet over the motor and secure with screws (Figure 3)
Figure 1
Figure 2
Figure 3
INSTALL
A
TION INSTRUCTION
18
3
4
1
