Installing the RBG 3200 | 2
B0640421_en | Operating instructions Control Panel RBG 3200
5
2 Installing the RBG 3200
take cable through
r
Fit the holding frame as shown at the desired position in the room using the
anchors and screws provided
Ä
The large grommet must be on the left!
Ä
It is recommended to install the device above a flush-mounted socket so that
there is plenty of space to stow away the bus cable.
2.1 Connecting the bus cable
For the bus connections between the individual modules, cable type
LIYCY paired
2x2x0.5
should be used. The connection to the 5-pin plugs should be carried out
according to the following diagram:
Braided shield
white
green
yellow
brown
Braided shield
white
green
yellow
brown
2.2 Setting end jumpers
NOTICE! To ensure smooth running of the bus system, the jumper must be set
on the first and last module.
When using a bus repeater, the two galvanically separated sub-networks must be
considered separately. The jumpers for each network must be set on the first and last
module.
