9
Set the channel number for the sensor with the channel slide switch.
(e.g. channel 1)
Insert 2 x AA size batteries into the battery compartment and close
the battery cover according to the polarity indicated on the battery
compartment.
4. the sensor is in synchronisation mode and will be automatically
detected by the display console within the next few minutes The
transmission status LED will start flashing every 1 minute.
NOTE:
- If you need to reassign the sensor channel, slide the channel slide
switch to the new channel.
position. To make the new channel number effective, press the [
RESET ] key on the sensor.
- Avoid placing the sensors in direct sunlight, rain or snow.
- To prevent the sensor(s) and the console from not being able to be
connected to each other during the setup of the new console, please
turn
first select the sensor(s), and then press the [ RESET ] key on the
main unit (not required for sensors).
PLACEMENT OF THE WIRELESS INDOOR SENSOR
Attach a screw to the wall where you want to hang the sensor.
Use the wall bracket to hang the sensor on the screw. You can also
place the sensor on a table by itself.
