43
2 . Under the current alert reading, press and hold [ ALERT ] key for 2 seconds to enter alert setting and
the alert reading will flash.
3 . Press [ Ʌ ] or [ V ] key to adjust the value or press and hold the key to change rapidly.
4 . Press [ ALERT ] key to confirm the value.
5 . Press [ ALARM ] key to toggle the regarding alert on / off.
6 . Press [ ALERT ] key to step to next alert reading.
7 . Press any key on the front side to save alert on /off status and back to normal mode, or it will
automatically back to normal mode after 30 seconds without pressing any key.
TO SILENCE THE ALERT ALARM
Press [ SNOOZE ] key to silence the alert alarm or let the alarm automatically turn off after 2 minutes.
NOTE:
- Once the alert is triggered, the alarm will sound for 2 minutes and the related alert icon and readings
will flash.
- If the alert alarm is automatically off after 2 minutes, the alert icon and readings will still keep flash until
the weather reading is out of the alert range.
- The weather alert will sound again when the weather readings falls into the alert range again.
7
Maintenance
Battery replacement
If the low battery indicator displayed in OUT or CH
section, it indicates that the current channel
wireless or outdoor 5-in-1 sensor battery power is
low. You should replace all the batteries in the
current channel sensor at once .
Cleaning the rain collector
1 . Unscrew the rain collector by turning it 30°anti-
clockwise.
2 . Gently remove the rain collector.
3 . Clean and remove any debris or insects.
4 . Install the collector when it is clean and fully
dried.
Cleaning Thermo- Hygrometer sensor of the outdoor unit
1 . Remove the 2 screws at the bottom of the
radiation shield.
2 . Gently pull out the shield.
3 . Carefully remove any dirt or insects on the
sensor casing (do not let the sensors inside get
wet).
4 . Clean the shield with water to remove any dirt
or insects.
5 . Install all the parts back when they are clean
and fully dried
