Froggit IP Observer WH2600 SE, Руководство по эксплуатации

Страница: 54 / 60

54
7.2 Measurement Specifications
The following table provides the specifications for the measured parameters.
Measurement Range Accuracy Resolution
Indoor Temperature 0 to 60 °C ± 1 °C 0.1 °C
Outdoor
Temperature -40 to 65 °C sensor
-5 to 60 °C battery range
(alkaline)
± 1 °C 0.1 °C
Indoor Humidity 1 to 99% ± 5% 1 %
Outdoor Humidity 1 to 99% ± 5% 1 %
Barometric
Pressure 300-1100hPa
(8.85 to 32.50 inHg)
+/-3hpa under 700-
1100hPa 0.1hPa
Light 0 to 400,000 Lux ± 20% 1 Lux
Rain 0
–
9999mm ± 10% 0.03mm
Wind Direction 0 - 360 º 10º 1º
Wind Speed 0-50m/s ± 1m/s or 10% (whichever
is greater) 0.1 m/s
7.3 Power Consumption
•
ObserverIp Receiver : 5V DC Adaptor (included)
•
Indoor Thermo-hygrometer-barometer sensor : 2xAAA batteries (not included)
•
Outdoor sensor array: 3xAA alkaline batteries (not included)
1. Maintenance
1. Clean the rain gauge once every 3 months as follows. Reference Figure 23.
Step 1: Make a note of the current rain totals by referencing the calibration panel
(reference Section 0). You will need to re-enter these values after the calibration
procedure
it complete.
Step 2: Pour water into the rain collector to moisturize the dirt inside rain bucket.
Step 3: Use an approximately 3 inch (80 mm) long cotton swab, and push the cotton
tip through the rain collector hole until is reaches the self emptying mechanism, and
press
until the mechanism no longer rotates.
Step 4: Rotate the cotton swab back and forth, removing dirt from the tipping
mechanism and rain collector hole.