Placement of the sensor:
To mount the unit on a wall or wooden beam:
Use a screw (screw ST D3.2*M2.0*6) to fix the bracket to the wall, then pa
the probe through the hole in the bracket as shown in Figure 3:
Attach the sensor to the bracket with the M12 hex nut and tighten the screw as
shown in figure 4: (Turn the nut by hand until it is tight, then use a spanner to
turn 1/3 to 1/2 turn and no
4
To mount the unit on a wall or wooden beam:
Use a screw (screw ST D3.2*M2.0*6) to fix the bracket to the wall, then pa
the probe through the hole in the bracket as shown in Figure 3:
Figure 3
Attach the sensor to the bracket with the M12 hex nut and tighten the screw as
shown in figure 4: (Turn the nut by hand until it is tight, then use a spanner to
turn 1/3 to 1/2 turn and no more. Do not over tighten).
Figure 4
Use a screw (screw ST D3.2*M2.0*6) to fix the bracket to the wall, then pass
the probe through the hole in the bracket as shown in Figure 3:
Attach the sensor to the bracket with the M12 hex nut and tighten the screw as
shown in figure 4: (Turn the nut by hand until it is tight, then use a spanner to
