Fritz!Box Fon, Установка, настройка и эксплуатация

Страница: 27 / 62

Installing FRITZ!Box Fon in Mac OS X
FRITZ!Box Fon – 2 Starting FRITZ!Box Fon Operation 27
Installing FRITZ!Box Fon in Mac OS X
1. Select “System Preferences / Network”. You receive the
message that a new port “Ethernet port en<No.>” was
found. Confirm the message by clicking “OK”.
2. Under “Show”, select the new port found, “Ethernet
port en<No.>”.
3. Confirm your entries with “Activate Now”.
FRITZ!Box Fon is now connected and ready for operation.
You can only connect to the Internet if Internet access is con-
figured. See the section “Basic Configuration of FRITZ!Box
Fon” on page 28 for information about how to configure an
Internet connection.
Installing FRITZ!Box Fon in a Linux Operating
System
The example of SUSE Linux 9.0 is used here to describe how
to install FRITZ!Box Fon to the USB port in Linux.
1. Open the YaST Control Center.
2. Select the option “Network Devices” and click “Network
Card”.
3. The “Network cards configuration” dialog appears.
4. Select “Other (not detected)” and the “Configure...”
button.
5. The device type of the network in the “Manual network
card configuration” window should be set to “Ether-
net”. Select the “USB” check box as well and click
“Next”.
6. In the input mask “DSL Configuration”, the PPP mode
should be set to Ethernet, for “Network cards to configure”
select “Other (not detected)”. Then click “Configure...”.
7. In the next dialog, “Network address setup”, select the
“Automatic address setup (via DHCP)” option. Click
“Next”.
FRITZ!Box_Fon-e.book Seite 27 Donnerstag, 4. November 2004 2:08 14