6
Using the device
CAUTION!
Before starting the machine, make sure that the
grinding bowl has been clamped correctly and that
there are no loose parts inside the device. There is a
risk of loose grinding bowls or parts being projected.
Failure to observe this will render void the guarantee,
and releases us from liability for any resulting damage
to the device as well as for any resulting personal injury.
NOTICE!
During grinding, the temperatures in the grinding bowl
may get very high.
In encased grinding bowls, the inserts are glued into
the casing with a two-component construction adhe-
sive.
The adhesive is resistant to temperatures up to approx.
140 °C. Above 140 °C, the adhesive will liquefy and
accumulate below the insert in the casing. When the
adhesive cools down, it solidifies and pushes the casing
up. That can cause irreparable damage to the insert.
The grinding bowl will definitely be rendered unusable.
Above temperatures of 200 °C, the adhesive will be
destroyed. The same applies for encased grinding bowl
lids.
V‐belt, seals, and motor require some time at the begin‐
ning before they can reach the optimal performance
and/or speed. This means that initially a well-filled and
heavy grinding set may operate at a lower speed than
after an introductory phase of approx. 1 ‐ 2 hours run‐
ning time.
6.1 Choice of grinding bowls and grinding balls
CAUTION!
If the grinding elements used are not genuine accesso-
ries, we assume no guarantee and exclude all liability
for damage to the device or for personal injury.
Using the device
- 28 -