Fristam Pumps FKL-150, Инструкция по эксплуатации и техническому обслуживанию, Страница: 28 / 50

Fristam Pumps
8
The rolling torque should be 7 in-lbs. if it is not, tighten or loosen the bearing locknut as needed.
m) Turn the rotors to check the timing. If the timing is off, one shaft will have to be removed and then
reinstalled.
n) Install the new rear oil seal into the drive shaft bearing cap.
o) Install the new bearing cap o-rings into the o-ring grooves in the bearing caps.
p) Install the bearing caps onto the gearbox. Secure with the bearing cap screws and tighten to the
specified torque (Table A, page 53).
q) Lightly oil the outside edge of the two front oil seals and press into the front bearing bores of the
gearbox.
r) Place the new gearbox cover gasket and gearbox cover on the gearbox and secure with the gearbox
cover bolts. Tighten to the torque specified in Table A, page 5.
s) Re-install the oil drain plug and vent plug onto the gearbox. Fill the gearbox with oil to the center of
the oil sight glass.
S
ETTINg ThE
R
OTOR
g
AP
ROLLING TORQUE
INDICATOR WRENCH
1265000100
2/5/03
Figure 41