Frigomat KISS 3 POWER Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 31 / 47

ENGLISH - 30
We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
x
Prepare the supplied brush and the OR disassembly
device and immerse them in the solution.
REMOVING AND CLEANING THE STANDARD DOOR
x
Remove the 2 knobs that block the door to the front of the
machine and place it on a clean work surface to
disassemble its parts:
5. Pull the dispenser lever down and remove the locking
pin of the distribution lever.
6. Remove the distribution lever and remove the piston by
pulling it upwards.
7. Remove the OR gaskets with the designated tool
supplied.
8. Immerse the previously disassembled components into
the tub with the sanitising solution and brush the
surfaces with care. Pay special attention to the running
chamber of the dispenser piston and to the seats of the
gaskets.
REMOVING AND CLEANING THE MONOBLOC RESIN
BEATER
x
Pull the beater towards you to remove it from the batch
freezing cylinder.
x
Recover the seal gasket placed on the back of the beater.
x
Place the previously disassembled components into the
tub with the sanitizer and brush the surfaces with care.
Pay particular attention to the surfaces of the scrapers.
REMOVING
AND CLEANING POWER SUPPLY
NEEDLE (GRAVITY models only).
x
Take the entire power supply needle previously removed
from the machine.
x
Remove the power supply needle from the mix inlet
regulator.
x
Emerge the previously disassembled components into the
tub with the sanitizer and brush the surfaces with care.
Pay special attention to the inner ducts of the needle and
the regulator.