14
FACTORS AFFECTING PERFORMANCE
Rinse Aid
Rinse aid greatly improves drying and reduces
water spots and filming.
Water "sheets" off dishes
rather than forming water droplets that cling and leave
spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of rinse aid
during the last rinse. If spotting and poor drying are
problems, increase the amount of rinse aid dispensed by
rotating the dial to a higher number. The dial is located
under the dispenser cap. The indicator will be dark when
full and will show clear when it is time to refill. On
models with a STATUS window, LO will appear at the
end of the cycle indicating that it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4 turn
counterclockwise and lift out. Pour in rinse aid until liquid
touches the indicated fill level. Replace cap.
Do not overfill since this can cause oversudsing. Wipe up
any spills with a damp cloth.
The dispenser holds enough for 35 to 140 washes,
depending on setting.
Adjustable setting
Dispenser Opening
Dispenser Cap
Indicator
More
Less
Water Pressure
The hot water line to dishwasher must provide water
pressure between 20 and 120 psi.
Low water pressure may occur when laundry or showers
are in operation. Wait until water use is reduced before
starting dishwasher.
Water Temperature
Hot water is needed for best dishwashing and drying
results. Water entering dishwasher should be at least
120°F (49°C) to give satisfactory results.
To check water temperature entering dishwasher:
• Turn on hot water faucet nearest dishwasher for
several minutes to clear cool water from pipes.
• Hold a candy or meat thermometer in stream of water
to check the temperature.
• If temperature is below 120°F (49°C), have a qualified
person raise the hot water heater thermostat setting.
The HEAT DRY option in combination with rinse aid
will enhance drying performance. The energy
required to use the HEAT DRY option costs pennies
per cycle. You may choose not to select the HEAT
DRY option; however you will have items in your
dish load that will not be completely dry at the end
of the cycle.
IMPORTANT
Before starting a cycle, run hot water to clear
cool water from pipe.