Frigidaire FTH61200C, Руководство пользователя

Страница: 7 / 12

Use of the hood - Safety
Warning: the hood may stop working during an electrostatic
discharge (e.g. lighting). This involves no risk of damage. Switch off the
electricity supply to the hood and reconnect after one minute.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
To avoid the risk of fire, clean the metal filter regularly, permanently control
pans containing hot oil and do not flame food underneath the hood.
Do not use the hood if it shows signs of damage or imperfection. Contact
an official distributor or Customer Service.
Accessible parts may heat up when using cooking appliances.
EN
Air Intake Speed (Fig 2)
The front panel has to be pulled its maximum extension so as to optimize the
extraction capacity.
The three setting switch (C-2) has the following functions:
0 – Stop / Off
1 – Low Speed
2 – High Speed
Switch on the Lamps (C-1 Fig 2)
Pull out the grill (G) more than 50mm
SUCTION VERSION
If the hood is to be installed as a suction hood, connect the plastic outlet piece (A)
supplied with the hood (150mm diameter pipe for better performance and lower
noise levels.
FILTERING VERSION (INTERNAL RE-CYCLING)
When there is no exhaust duct for venting out-door, you can use a carbon filter
(D). The air is depurate by the filter and put again in the surrounding.
The air is released in the room through a connecting pipe, which goes through
the hanging cupboard and is connected to the connecting ring supplied (A) Fig 1.
To use the appliance in this version, proceed as follows:
1. Open the grids (E)
2. To proceed to change the charcoal filter (D), the screw (B) has to be
removed.
3. Reinstall the grids.