5
PACKAGING & NORMAL SOUNDS
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
• The appliance shall be installed in
accordance with national wiring
regulations.
NOTE
•
Do not use this device to turn the unit on
or off.
•
Always make sure the RESET button is
pushed in for correct operation.
•
The power supply cord must be replaced
if it fails to reset when either the TEST
button is pushed, or it cannot be reset. A
new one can be obtained from the
product manufacturer.
•
If power supply cord is damaged, it
CANNOT be repaired. It MUST be replaced
by one obtained from the product
manufacturer.
READ THIS SECTION BEFORE ATTEMPTING
TO OPERATE AIR CONDITIONER.
Unit must be upright for one hour prior to
operating.
The power supply cord contains a current
device that senses damage to the power
cord. To test your power supply cord do the
following:
Operation of Current Device
Plug in & press RESET
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO
buttons on the plug head. Press the TEST
button. You will notice a click as the
RESET button pops out.
3. Press the RESET button. Again you will
notice a click as the button engages.
4. The power supply cord is now supplying
electricity to the unit. (This is also
indicated by a light on the plug head).
Packaging
Remove all packaging from inside the
carton, along with any inserts placed into
the side louvers.
Remove the plastic ties and foam pad that
secure the compressor to the fan shroud
(where applicable). See diagram.
Normal Sounds
1
2
3
4
5
foam pad + plastic ties
Packing Inserts
