Operating Instructions
NOTE
The following instructions represent the touch pad. The same instructions can be used for the remote control.
PRESS ON/OFF BUTTON
DO THIS:
Air Conditioner Features & Operating Instructions
Before you begin, thoroughly familiarize yourself with the control panel and remote
control and all its functions (as shown below). The unit can be controlled by the
touch pad alone, with the remote control, or with the Frigidaire app*.
*Refer to the Quick Start Guide that came with your Smart Air Conditioner for detailed instructions on setting up your air
conditioner for connected operation from your smart phone or tablet.
Note: The display and indicator lights will turn off if the unit does not receive any control signal in 60 second.
Press any button then the display will resume.
ELECTRONIC CONTROL
Air Conditioner Features
6
YOU WILL SEE:
.
d
e
v
r
e
s
e
r
s
t
h
g
ir
l
l
A
.
c
n
I
,
s
t
c
u
d
o
r
P
e
m
o
H
x
u
l
o
r
t
c
e
l
E
9
0
0
2
TO TURN UNIT ON:
Battery Size: CR2025
TO REPLACE BATTERY
Turn Remote Control upside down. Squeeze tab
and pull to remove battery tray. Place battery in
tray with POSITIVE(“+”) side facing UP,
according to diagram. Re-insert battery tray.
TAB
REMOTE CONTROL
ADJUSTS
TEMPERATURE
DISPLAYS
TEMPERATURE
SETS FAN
SPEED
SET MODE
TURNS UNIT
ON OR OFF
SCHEDULE
INDICATOR
CHECK FILTER
RESET BUTTON
WIFI
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin
cell battery is swallowed or enters the body, it
can cause severe internal burns and can lead
to death in as little as 2 hours. Always
completely secure the battery compartment.
If the battery compartment does not close
securely, stop using the product, remove the
batteries, and keep it away from children. If
you think batteries might have been swallowed
or placed inside any part of the body, seek
immediate medical attention.
The cells shall be disposed of properly,
including keeping them away from children;
Even used cells may cause injury.
WARNING: Chemical Burn Hazard.
Keep batteries away from children.
NOTE: The unit will run in energy saver(econ) mode
when powered on each time, if last shutdown is in cool
or energy saver(econ) mode. In this mode, the fan will
continue to run for 3 minutes after the compressor shuts off.
The fan then cycles on for 90 seconds at 10 minute intervals
until the room temperature is above the set temperature, at
which time the compressor turns back on.
