background image

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

2

Important Notes to the Installer

1.

Read all instructions contained in these installation
instructions before installing range.

2.

Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.

3.

Observe all governing codes and ordinances.

4.

Be sure to leave these instructions with the consumer.

Important Note to the Consumer

1.

Keep these instructions with your owner's guide for
future reference.

IMPORTANT SAFETY

INSTRUCTIONS

Installation of this range must conform with local codes or, in
the absence of local codes, with the National Fuel Gas Code
ANSI Z223.1—latest edition when installed in the United
States.

This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will find
them in the Use & Care Manual, read it carefully.

Be sure your range is installed and grounded properly
by a qualified installer or service technician.

This range must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No  .70—
latest edition when installed in the United States.
See Grounding Instructions on page 5.

Before installing the range in an area covered with
linoleum or any other synthetic floor covering, make
sure the floor covering can withstand heat at least
90°F above room temperature without shrinking,
warping or discoloring.
 Do not install the range over
carpeting unless you place an insulating pad or sheet of
1/4-inch thick plywood between the range and carpeting.

Make sure the wall coverings around the range can
withstand the heat generated by the range.

Do not obstruct the flow of combustion air at the
oven vent nor around the base or beneath the lower
front panel of the range. 
Avoid touching the vent
openings or nearby surfaces as they may become hot
while the oven is in operation. This range requires fresh
air for proper burner combustion.

 Never leave children alone or unattended

in the area where an appliance is in use. As children grow,
teach them the proper, safe use of all appliances. Never
leave the oven door open when the range is unattended.

 Stepping, leaning or sitting on the doors

or drawers of this range can result in serious injuries and
can also cause damage to the range.

Do not store items of interest to children in the
cabinets above the range. 
Children could be seriously
burned climbing on the range to reach items.

To eliminate the need to reach over the surface
burners, cabinet storage space above the burners
should be avoided.

Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.
Excessive flame is hazardous.

Do not use the oven as a storage space. This creates
a potentially hazardous situation.

Never use your range for warming or heating the
room.  
Prolonged use of the range without adequate
ventilation can be dangerous.

Do not store or use gasoline or other flammable
vapors and liquids near this or any other appliance.
Explosions or fires could result.

Reset all controls to the "off" position after using a
programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

Remove broiler pan, food and other utensils before
self-cleaning the oven. 
Wipe up excess spillage. Follow
the precleaning instructions in the Owner's Guide.

Unlike the standard gas range, THIS COOKTOP IS
NOT REMOVABLE. 
Do not attempt to remove the
cooktop.

 DO NOT MAKE ANY ATTEMPT TO

OPERATE THE ELECTRIC IGNITION OVEN DURING AN
ELECTRICAL POWER FAILURE. RESET ALL OVEN
CONTROLS TO "OFF" IN THE EVENT OF A POWER
FAILURE.

The electric ignitor will automatically re-ignite the oven
burner when power resumes if the oven thermostat control
was left in the "ON" position.

When an electrical power failure occurs during use, the
surface burners will continue to operate.

During a power outage, the surface burners can be lit with
a match. Hold a lighted match to the burner, then slowly turn
the knob to the LITE position. Use extreme caution when
lighting burners this way.

Содержание FGFL66ASB









Отзывы: