17
Use caution when
replacing the burner cap so the electrode
is not damaged. This may cause a delayed
ignition or prevent the burner from
igniting.
Any additions, changes or
conversions required in order for this
appliance to satisfactorily meet the
application needs must be made by an
authorized Frigidaire Distributor or
Qualified Agency.
Note:
The burner cap assembly refers to
all parts of the sealed burner unit (burner
cap, burner pan (some models), trim ring
(some models), locating tab, burner base
and electrode).
Unlike the standard gas range, THIS
COOKTOP IS NOT REMOVABLE. Do not
attempt to remove or lift the cooktop.
General Cleaning
(continued)
To Clean the Cooktop
The cooktop is designed to make cleaning easier. Because the four burners are
sealed, cleanups are easy when spillovers are cleaned up immediately.
To clean, wipe with a clean, damp cloth and wipe dry.
To Clean the Contoured Well Areas, Burner Cap Assembly, Trim Ring
(some models), Burner Pan (some models) and Burner Base
The contoured well areas, burner cap assembly, trim ring (some models), burner pan
(some models) and burner base should be routinely cleaned. Keeping the burner
ports clean will prevent improper ignition and an uneven flame. See instructions
below.
To Clean the Contoured Well Areas
The contoured well is a recessed area located around each burner unit. If a spill occurs
in one of the four well areas, blot up spill with an absorbent cloth. Rinse with a clean,
damp cloth and wipe dry.
To Remove the Burner Cap Assembly
The burner cap assembly parts differ per model. Your assembly will consist of one
of the following combinations: burner cap and trim ring; burner cap and burner pan;
or burner cap, trim ring and burner pan. Remove in the following order: (1st) burner
cap, (2nd) trim ring and (3rd) burner pan.
Do not operate the burners without
the burner cap assembly in place.
To Clean the Burner Cap, Burner Pan (some models) and Trim Ring (some
models)
Use a soap-filled scouring pad or a mild abrasive cleanser to clean burner caps, trim
rings and burner pans.
To Clean the Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned. Use a small-
gauge wire or needle to clean small slots or holes.Use care to prevent damage to the
electrode. If a cleaning cloth should catch the electrode, it could break or damage
the electrode. If the electrode is damaged or broken, the surface burner will not light.
For proper flow of gas and ignition of the burnerDO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Gas
must flow freely through the small hole in the brass orifice for the burners to light
properly. If the orifice gas opening becomes soiled or clogged, use a small-gauge
wire or needle to clean. ALWAYS keep the burner cap assembly in place whenever
a surface burner is in use.
To Replace the Burner Cap Assembly
Make sure the burner cap assembly is thoroughly dry before placing back on the
burner.
1. Lower burner pan (some models) into place around the burner base.
2. Replace trim ring (some models).
3. Find the locating tabs on the burner cap and place in the locating slots in the
burner base. Make sure each burner cap is properly aligned and level.
4. Turn the burner on to determine if it will light. If the burner does not light after
cleaning, contact an authorized servicer. Do not service the sealed burner
yourself.
Содержание FGF354BGWC
Страница 23: ...23 ...
