Frigidaire FGF354BGWC, Руководство пользователя

Страница: 22 / 25

22
Oven does not operate.
Entire appliance does not operate.
Cooktop and/or oven light (some models)
does not work.
Oven smokes excessively during broiling.
Poor baking results.
Self-Cleaning cycle does not work.
Soil is not completely removed.
Flames inside oven or smoking from vent.
Be sure the electronic oven controls are set correctly for the desired function. See Setting
Oven Controls in this Owner's Guide or Entire Appliance Does Not Operate (see below).
Be sure regulator gas valve is "ON". See installation instructions.
Make sure electrical cord/plug is plugged tightly into outlet (electric ignition models only).
Service wiring not complete. Contact servicer or dealer.
Electrical power outage (electric ignition models only). Check house lights to be sure. Call
your local electric company for service. Surface burners can be lit manually. See Setting
Surface Controls in this Owner's Guide.
Be sure gas supply is turned on.
Burned-out or loose bulb. See Changing Cooktop and/or Oven Lights (some models)
section in this Owner's Guide to replace or tighten the bulb.
Oven door is open. Door should be closed during broiling.
Meat too close to broil burner. Reposition the rack to provide more clearance between the
meat and the broiler.
Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges to
prevent curling, but do not cut into the lean.
Broiler pan used without grid or grid covered with foil. DO NOT use the broiler pan without
grid or cover grid with foil.
Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is necessary
when broiling frequently. Old grease or food spatters cause excessive smoking.
Many factors affect baking results. Make sure the proper rack position is used. Center food
in the oven and space pans to allow air to circulate. Allow the oven to preheat to the set
temperature before placing food in the oven. Try adjusting the recipe's recommended
temperature or baking time. If you feel the oven is too hot or cool, see Adjusting Oven
Temperature in this Owner's Guide.
Controls are not set properly. Follow instructions under Oven Cleaning.
Self-cleaning cycle was interrupted. Stop time must be set 2 to 4 hours past the start time.
Follow steps under "Stopping or Interrupting a Self-Clean Cycle" under Oven Cleaning .
Time of day not set on oven control. Follow instructions under Setting the Clock and Minute
Timer .
Failure to clean bottom front, top of oven or door areas outside oven seal. These areas are
not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before
starting the self-clean cycle. Burned-on residue may be cleaned with a stiff nylon brush and
water or a nylon scrubber. Be careful not to damage the oven gasket.
Excessive spillovers in oven. Set self-clean cycle for a longer cleaning time.
Excessive spillovers in oven. This is normal, especially for pie spillovers or large amounts of
grease on the oven bottom. Wipe up excessive spillovers before starting the self-clean cycle.
If flames or excessive smoke are present, stop the self-clean cycle and follow the steps under
"Stopping or Interrupting the Self-Clean Cycle" in the Oven Cleaning section.