1 7
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Push
CANCEL
to clear the display
and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record
the fault number, push the
CANCEL pad
and contact an authorized servicer.
Poor installation. Place a level on an oven rack in center of oven. Contact installing
agent if rack is not level.
Kitchen cabinet misalignment may make oven appear to be unlevel. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
Make sure cord/plug is securely plugged into electrical outlet.
Cord/plug is not installed or connected. Contact your dealer, installing agent or
authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
Power outage. Check house lights to be sure. Contact your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions in the
Oven Control Guide
to set the
controls.
House fuse has blown or circuit breaker has tripped immediately following installation.
House fuse may not be fully engaged. Check fuse or engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been installed
and previously operating. Call an authorized servicer.
Wall oven is not properly connected to gas supply. Check connection (see Installation
Instructions).
Make sure gas supply shut-off valve is opened before turning on the oven after
installing the wall oven.
Burned out or loose bulb. Follow instructions under
Changing Oven Light
to replace
or tighten the bulb.
OCCURRENCE
Oven Control Beeps and Displays -F1-
-F3- or -F9-.
Oven is not level.
Entire appliance does not operate.
Oven does not operate.
Oven light does not work.
Avoid Service Checklist
Before you call for service,
review this list. It may save you time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this appliance.
This oven is equipped with an electronic oven controller (some models). Among its many features is a full time oven circuit
diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are
all operating correctly. If at any time one of these systems fail, the controller will immediately shut down operation, and will beep
and flash an error code of -F1-, -F3- or -F9- in the display window.
Содержание FGB24T3ASA
Страница 19: ...1 9 Notes ...
