in anti-clockwise, steam will come out from the frothing device. Froth milk in the way: moving the jug
round from up to down.
Note:
Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
5. When the required purpose is reached, you can turn the steam control knob to the minimum position.
Note:
Clean steam outlet with wet sponge immediately after steam stops generating, but care not to
hurt!
6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste and
if desired, sprinkle the froth with a little cocoa powder.
7. Press and release the ON/OFF button to the higher position which is the
“
O FF
” position to cut the
power source off.
Note:
we recommend you allow the maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occurr in your Espresso coffee .
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothing device) can be used to make hot beverages like drinking chocolate,
water or tea.
Method:
1. Remove the detachable tank and fill it with desired water, the water level should not exceed the
“MAX” mark in the tank. Then place the tank into the appliance properly.
2. Then connecting the appliance to power supply source.
3. Press down the ON/OFF button to the lower position which is
the “
” position, the power indicator
(red) is illuminated.
4. Press down the pump control button to the lower position which is
the “
” position, make sure the
coffee/steam button is on the higher position which is the
position, the pump will pump water,
when there is water flowing out, close the pump immediately by pressing down the coffee/steam
button to the lower position which is the
position and wait for a moment, the appliance begins to
be heated until the green lamp is illuminated, it shows the heating is finish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the steam control knob in anti-clockwise slowly
to start making steam.
7. When the required temperature is reached, you can turn the steam control knob to the minimum
position.
8. Press and release the ON/OFF button to the higher position which is the
“
O FF
” position to cut the
power source off.
