(green) is illuminated, it shows the pre-heating is finish. Pressing the pump to the lower position
which is the
“
” position again, will let the water flow out.
6. After water not dropping out any more, you can pour the water in each container out then clean them
thoroughly, now you can start brewing.
Note:
There may be noise and no water coming out when pump the water on the first time, it is normal,
you should turn the steam control knob to the opening position to release the air in the appliance. After
about 20seconds, the noise will disappear, and the water will come out.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you to preheat the appliance before
making coffee, including the funnel, filter and cup, so that the coffee flavour can not be
influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level
should not exceed the “MAX” mark in the tank. Then place the tank into the appliance properly.
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the “Insert” position, and you can fix them
into coffee maker firmly by turning it anticlockwise until it is at the
lock
position.(See fig. 1).
3. Place an espresso cup (your cup) on the cup warming plate to warm and dry it, to later pour the
coffee to the cup.
4. Then connect the appliance to power supply source. Make sure the steam control knob is on the
minimum position.
5. Press the ON/OFF button to the lower position which is the
“
” position, the power indicator (red)
will be illuminated, make sure the coffee/steam button is on the higher position which is the
position. Press down the pump control button to the lower position which is the
“
” position, when
the water is flowing out, close the pump immediately by pressing the pump control button again to
the higher position of “
STO P
”. The purpose of the step is to pump the water of the tank into the
housing.
6. When the ready indicator (green) is illuminated, you should press down the pump control button to
the lower position which is
the “
” position again, there will be hot water flowing out. When the
ready indicator (green) is extinguished, close the pump by pressing the pump control button again to
the higher position of “
STO P
”. The pre-heating is finished. Before
making coffee, first clean out the water in the drip tray.
MAKE ESPRESSO COFFEE
1. Remove the funnel by turning it in clockwise, .Add ground coffee
to steel mesh with measuring spoon, a spoon ground coffee
powder can make about a cup of top-grade coffee, then press the
INSERT
LOCK
Fig.1
