16
Rittal CMC III Access Control
6 Operation
EN
Parameter
Explanation
Value
Current status of the handle used (0 =
handle closed, 1 = handle open).
Status
Current locking status.
Tab. 11: Displays at "Handle" level
Note:
The logic above for the "Value" parameter
applies to handles DK 7030.610 and DK
7030.611. The logic may be inverted for
other handle systems (0 = handle open, 1 =
handle closed).
Note:
There is no error message if the handle is
disconnected from the Access Control. The
handle status changes to "Inactive" and a
corresponding message is generated in the
log information. The status change can be
queried in a task and linked with an action.
Note:
If the handle is opened with a master key,
the CMC III PU displays an alarm message.
This can be eliminated again by closing the
handle.
6.6.4 KeyPad
The settings for the coded lock and transponder reader
are configured at the "KeyPad" level.
Parameter
Explanation
DescName
Specific description of the coded lock or
transponder reader used.
Command
Selecting the "On" entry activates the
connected coded lock or the transponder
reader.
Accordingly, a connected reader unit can
be deactivated by selecting the "Off" entry
so that it cannot be used to open the
door.
Tab. 12: Settings at "KeyPad" level
The following parameters are also displayed for the
coded lock/transponder reader:
Parameter
Explanation
Status
Indicates whether a coded lock or
transponder reader has been connected
(active) or not (inactive), or the reader unit
has been deactivated (off).
Tab. 13: Displays at "KeyPad" level
6.6.5 LED
The settings for the LED display in the handle are con-
figured at the "LED" level.
Parameter
Explanation
Mode
Control of the LED display in the handle.
"Off": LED display switched off perma-
nently.
"Access": Display in accordance with
the switching status of the handle or the
status of the Access Control.
"Access & beeper": Similar to "Access",
an acoustic signal also sounds in the
event of a fault.
"CMC": Display in accordance with the
status of the CMC III PU.
"CMC & beeper": Similar to "CMC", an
acoustic signal also sounds in the event
of a fault.
"Task": Display in accordance with the
evaluation of a task ("LED.Command"
variable).
"Task & beeper": Similar to "Task", an
acoustic signal also sounds in the event
of a fault.
Command
The colour of the LED can be set when
the "Task" mode is selected. The colour
is retained until the task is next initiated. If
"Custom" is selected, the colour can be
defined using the three components: red,
green and blue.
Red
Red component of the colour.
Green
Green component of the colour.
Blue
Blue component of the colour.
Tab. 14: Settings at the "LED" level
6.7 Manual changes to the "access.cmc3"
file
Alternatively, the access authorisation settings can also
be made directly in the "access.cmc3" file. This file is
created automatically in the "upload" directory of the
CMC III Processing Unit when it is started for the first
time.
