A
B
SWX CE
12
GB
Installation and operating instructions
General Instructions
Read these instructions carefully before
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid if the product is used
in the manner intended and in accordance
with the instructions.
Application
SWX is a range of fan heaters suitable
for environments with strict demands on
materials and safety. Models are available for
use in dusty or corrosive environments. Fan
heater SWX has a robust design, adapted to
the requirements of harsh environments.
Supplied with air director with individually
adjustable louvres that direct the air flow on
one plane.
SWX CE has an inspection hatch with quick
release.
Protection class: IP65.
SWX CE
The fan heater is available in two sizes,
SWXCE12 and SWXCE22. They have been
adapted specifically for use in corrosive
environments, such as offshore or chemical
industry.
Fitting the wall brackets
1. Remove the eight screws indicated by the
arrows in picture A.
2. Install the brackets with the holes toward
the fan motor, as shown in picture B.
• Meets the requirements for corrosion class
C5-M.
• Uses hot water as the energy medium.
• Casing, air deflector grille and brackets
made of acid-proof stainless steel,
EN 1.4404.
• Water coil with copper tube and aluminium
fins coated with ElectroFin E-coat. This
means that the entire coil is dip-coated with
flexible epoxy polymer with 100% coverage.
Thermal loss less than 1%.
• Protection class IP65 – protected against
dust and water jets.
• Inspection hatch with quick release.
• Fitted with draining plugs for removing
dirty water after spraying.
• Supplied without any automation and a
single fan speed.
• Wall brackets supplied for mounting of the
fan heater on the wall for a horizontal air
stream, or in the ceiling for a vertical air
stream.
Tip for installation
Leave the protective patch until the
installation is complete or use gloves that do
not imprint on the stainless steel plate.
