SIRe Competent Air Curtains Water
19
GB
Enter ID
The control system can control one or more
units in parallel (max 9). Each unit must have
a unique ID number (1-9) which is set in the
ID selector of the PC board.
E.g.) Unit 1: ID=1, unit 2: ID=3
If the external control for some reason has
not been installed the unit can still be run
temporarily. The ID selector is then set to
mode 0 in the image below. The function is
half speed and heating on.
When the ID number must be changed the
unit must be disconnected from power.
Quick guide / Start up
Check that all constituent parts are present
(see section Constituent parts).
Advice about location
PC board HUB SIReC1X is installed close
to the unit. Control unit SIReUA1 has an
integrated room temperature sensor and
is installed so that it is easily accessible
to the user. RJ12 modular cables, which
are available in different lengths, are used
to connect the PC board and the control
unit. Longer cables are available as options.
Maximum cable lengths see section Options.
To prevent unauthorised people from
accessing the Control unit it can instead
be placed in another area and an external
room sensor, SIReRTX (option), can be
installed in the entrance to sense the correct
temperature. Maximum cable lengths see
section Options.
Connect the system
Control board Base SIReB1(X) in/at the unit
and control unit SIReUA1 are connected
by PC board HUB SIReC1X with RJ12
modular cables. In SIReB1(X) the unit is also
connected further with RJ12 modular cable if
several units are to be connected in parallel.
If external room temperature sensor
SIReRTX (option) is used it is connected
using modular cable RJ11 on the PC Board
HUB SIReC1X.
The actuator for water control and door
switch SIReDC is connected to the terminal
block on PC board HUB SIReC1X.
When required for fixed installation
the supplied cable and plug are removed.
Installation is carried out according to the
applicable regulations.
Wiring diagram
The wiring diagram is in a separate section at
the end of this manual.
When external PC board Base SIReB1X is
used, wiring between the PC board base and
the air curtain unit must be done. Please see
separate manual for SIReB1X
Set language
English
Start-up guide
Set temp. unit
°C
°F
Start-up guide
Set date
2011
-05-28
YYYY-MM-DD
Start-up guide
Set time
14
:07
24h format
Start-up guide
Function test
Start test
Skip test
Start-up guide
Screen function test
Fan step 1-5
Heating step off-1
Start-up guide
Function test
Test completed
Restart test
Start-up guide
Start-up finished
Proceed
Restart wizard
Start-up guide
Checking system
Startguide
1
4
7
6
5
3
2
Start up
System supplied with power. At the first start
up, the start-up wizard is run and the basic
settings are made. Fan and heating steps
are tested through the test program
.
Then a
status window is displayed.
Each unit should have
a unique ID on its
SIReB1(X) card.
To run the unit
temporarily without
external control select
mode 0.
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
