PCW
68
GB
Connection
General Instructions
• Perform electrical connections according
to applicable laws and regulations for the
relevant country.
• Install an isolator switch upstream, with a
minimum break gap of 3 mm.
The unit must always be earthed.
Always disconnect the unit from the mains
before opening the unit.
Connection
The unit is equipped with a terminal block on
the inside panel on the opposite side to the
water connections. Follow the wiring diagram
in these instructions when connecting.
The installer must insert the connection
cables in the unit through the access points:
• Wall mounted model, use the rear access
points that correspond to the side panel.
• Floor model, use the cutout inside the foot
(only models with feet).
The terminal block on the fan convector
is designed for connection to the different
control units, according to the instructions
in the section ”Control”.
Note that cables
connected on the terminal block are
standard versions and must always be
connected as specified in the relevant control
unit's wiring diagram.
All control units for installation on the
unit have a quick release terminal board
(MC). Connect this terminal board to the
corresponding terminal (MFC) on the side
panel. Remember to tighten the screws on the
individual sockets to ensure correct electrical
contact. Failure to follow these instructions
can lead to serious damage.
Cleaning, maintenance and spare parts
Important!
Ensure that the unit is disconnected from
the power supply before starting cleaning or
maintenance.
The unit may only be maintained by
authorised personnel.
Fan
No maintenance required.
Heat exchanger
No maintenance normally required.
Filter
Unhook the filter holder using a suitable tool
and pull out the filter from the grooves.
Regularly clean using a vacuum cleaner or
shake the filter carefully.
Replace the filter when it can no longer be
cleaned.
Spare parts
When ordering spare parts, always give
the unit model and a description of the
components.
Important!
Always reinstall the filter after cleaning.
Packaging
Packaging materials are chosen with
consideration to environment and are
therefore recyclable.
Handling of product at end of working life
This product may contain substances
necessary for functionality of product but
potentially dangerous for the environment.
The product should not be disposed
mixed with general household waste but
delivered to a designated collection point for
environmental recycling. Please contact local
authority for further details of your nearest
designated collection point.
