PCW
66
GB
General Instructions
Read these instructions carefully before
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid if the product is used
in the manner intended and in accordance
with the instructions.
Application
The PCW fan convectors are designed to heat/
cool homes, sports halls, industrial, buildings
commercial premises and public buildings.
The units are supplied with warm or cold
water depending on whether the surrounding
area is to be heated or cooled.
The unit consists of:
Casing
in prepainted galvanised sheet steel.
Easy to remove to access the unit.
• The exhaust grille at the top of the casing
can be altered with fixed louvres.
The fan unit
consists of a very quiet
centrifugal fan. The aluminium fan wheel is
static and dynamically balanced and directly
connected to the motor shaft.
The fan motor
has 6 speeds, 3 are connected
from the factory and indicated as max, med
and min. The motor has an built-in thermal
fuse with automatic reset and is mounted on a
vibration damper.
IP20, class B. 230V~.
The water coil
consists of copper pipe with
aluminium fins. Coils with three pipe rows
have two connections 1/2" with internal
thread. Venting and drain nipples have a
diameter of 1/8".
PCW can be provided with an extra
supplementary 1 row water coil, for heating
only. Coils have a connection diameter of 1/2"
with internal thread.
• 3 row water coil for heating or cooling, 2
pipe system.
• 3 row coil for c 1 row coil for
heating, 4 pipe system.
The connections are located to the left as
standard, seen from the front. The units can
be supplied with the connection on the right-
hand side if required.
Replaceable
synthetic filter.
Condensation box
made of plastic. L-profile
securely mounted in the fan convector.
Mounting (Fig.1 p.3)
Check that the air intake is not blocked when
the unit is positioned. (See fig.1A.)
For installation against glazed surfaces or
where there are no walls, the unit can be
mounted on the floor using feet (accessory).
For versions without feet, a bottom panel is
supplied to prevent access to parts inside the
unit. (See fig.1C.)
When installing PCW in the ceiling, note
that hot air rises and ensure a good mixture of
air in the premises. Also note that the exhaust
grilles must be positioned so that the air flows
downwards.
Warning!
For horizontal mounting in the ceiling, the
unit must always be installed with a fall
of about 8 mm towards the condensation
outlet.
(See fig.1D.)
The installer can select other methods
for installation, on the condition that it is
performed according to the applicable laws.
1. When opening the packaging take care
to place the package the correct way up,
according to the instructions. Slacken off
the two screws that hold the unit frame
to the casing before lifting the frame out
of the packaging. The screws are on the
lower section of the unit and must be
saved for installing the casing.
2. Secure the fan convector frame to the
wall. Position the four mountings (M8
screws are recommended) to fit the four
slots in the frame. (See fig.1C.)
3. Align the casing over the frame and secure
from the front using the supplied screws.
Slide the air filter into the grooves and
lock the filter holder into place.
Assembly and operating instructions
