FRIATEC FRIAMAT, Руководство по эксплуатации

Страница: 27 / 36

27
7.3 Overheating
If used continuously for long periods your FRIAMAT ® model could overheat.
To avoid damage to the unit a temperature monitor has been fitted, and on
the basis of this your FRIAMAT
® model will calculate, before the fusion
process, whether the temperature rise anticipated due to the fusion process
is acceptable. If the calculated temperature does not lie within the permitted
range the message “Allow the unit to cool down” will appear on the display.
Since the power consumption of various electrofusion fittings will differ there
may be a possibility of fusing a different fitting.
7.4 Fusion interruption
If the fusion is broken off because, e.g. the power supply has been interrupted
during a fusion run, the fusion can be repeated after removing the cause of
the problem and after allowing the fitting to cool down completely (this is
dependent on the fitting manufacturer; always comply with the instructions
for use from the fitting manufacturer in question).