Fri-Jado STG 5-I, Инструкция по эксплуатации, Страница: 9 / 48

9
WARNING
Do not store or use gasoline or other flammable vapors or liquids in the
vincinity of this appliance
1.2 LEGS / CASTERS
Each oven and warmer is furnished on 2” (50 mm) legs. Stacked units are provided
with casters.
1.3 SUPPLEMENTAL INSTALLATION INSTRUCTIONS
(For model STG(W) 5 and STG(W) 7 units for fixed wiring and stacked or placed
on bases with casters)
WARNING
Safety standards require that, when this appliance is properly connected to the
electrical power supply using a permanently connection, adequate means be
provided to limit movement of the appliance without depending on or transmitting
stress to the electrical conduit.
This means that, as part of the installation, the
base or bottom unit of stacked models must be secured to the building
structure (typically either wall or floor) to limit the movement of the appliance
and, thus, helping to prevent damage to the conduit during cleaning,
maintenance and service operations.
A tether bracket, as shown on the drawing below, is provided with the base or
stacking kit. Based on the routing of the flexible conduit, the bracket must be installed
along with the caster to one corner of the base using the hardware provided. The
remaining open hole in the center of the tether bracket is to be used to secure one
end of the tether (locally supplied chain, cable, etc.). The other end of the tether is to
be secured to an anchoring point in the building structure.
Note:
Length of tether
must be shorter than the flexible conduit to make sure that during appliance
movement, no stress is transmitted to the conduit.