39
3.6 LOADING ACCESSORIES INTO THE OVEN
If you are loading a STG5, skip steps 2-7
1. Turn the Main Switch Dial to “
I
”
2. Press
to rotate rotor
3. Press
to stop rotation when the hole pattern is located at the bottom of the
oven as shown in the left figure below.
Hole pattern
Right position
Wrong position
4. Verify that the hole pattern is identical to the illustrated hole pattern shown in
middle figure above.
5. If the hole pattern does not mach the middle illustrated hole pattern, but does
match the hole pattern as in the right figure above:
a. Take the rotor assembly out of the oven.
b. Flip rotor assembly.
c. Place rotor assembly back in oven.
d. Repeat steps 2-4 above.
6. Load accessory with product into oven. Make sure the product is distributed
evenly. (See the next page for further instructions on loading specific
accessories into the oven.
7. Press
to rotate rotor.
8. Press
to stop rotation.
9. Load accessory with product into the oven.
10. Repeat steps 7-9 until all loading is complete.
11. Close oven door.
Содержание STG 5-I
Страница 4: ...4 ...
