Fri-Jado MCC-120 H, Руководство по обслуживанию

Страница: 57 / 126

Rev.5 Service Manual MCC Hot USA 20220500
Page 57
Doc. nr.
9124582
Rev.
Registration form.
Danfoss ERC 211 – 95 °C
Pagina 1 van 1
MCC HOT FS
Note: Use tool
STICK 19
for inserting parameters and only change yellow arced parameters manually!
r00 Temperature set point
95 °C
r01 Differential
1 K
r02 Min set point limitation
0 °C
r03 Max set point limitation
99 °C
r04 Display offset 0
°C
r05 Display unit (°C/°F) °C
r09 Calibration of Sair 0.0 °C
r12 Main switch
1
r13 Night set back
0
r40 Thermostat reference displacement
0
r96 Pull-down duration
0
r97 Pull-down limit temperature 0
A03 Delay for temperature alarm
(normal conditions)
30 min
A12 Delay for temperature alarm
(pull down/start-up/defrost)
60 min
A13 High temperature alarm limit 100 °C
A14 Low temperature alarm limit
-30 °C
A27 DI1 delay
30 min
A37 Condenser high alarm limit
80 °C
A54 Condenser high block limit
85 °C
A72 Voltage protection enable
no
A73 Minimum cut-in voltage
0 V
A74 Minimum cut-out voltage 0 V
A75 Maximum voltage
270 V
d01 Defrost method
(no=no defrost, nAt=natural)
no
d02 Defrost stop temperature
6 °C
d03 Defrost Interval
8 hr.
d04 Max. defrost time
30 min
d05 Defrost delay at power up
0 min
d06 Drip delay 0 min
d10 Defrost stop sensor
(non=time, Air=Sair)
non
d18 Compressor accumulated
0 hr.
d30 Defrost delay after pull-down
0 min
c01 Compressor minimum ON time
0 min
c02 Compressor minimum OFF-time
0 min
c04 Compressor OFF delay 0 sec
c70 Zero crossing selection yES
o01 Delay of outputs
0 sec
o02 DI1 configuration oFF
o03 Serial address
0
o05 Password
no
o06 Sensor type selection
(n5=NTC5 K, n10=NTC10 K, Ptc=PTC,
Pt1=Pt1000)
Ptc
o07
Cooling/heating
(rE=refrigeration / Ht=heat)
Ht
o15 Display resolution (°C)
0.1
o23 Relay counter
0
o61 Predefined applications AP0
o67 Save settings as factory no
o91 Display at defrost
d
P73 DI1 input polarity
no
P76 Keyboard lock enable
no
u01 Air temperature (Sair)
- °C
u02 Read the present regulation refer-
ence
-
u10 DI1 input -
u13 Status of night operation
-
u58 Compressor relay status
- -
u80 Firmware version readout
-
9.1
Parameter MCC Hot Settings (Full Serve)