120-277 VAC
POWER SUPPLY
UV LAMP
BLUE CABLE
DISCONNECT
L1-BLACK
L2 or N-WHITE
GND-GREEN
4
Lamp Replacement
The germicidal UV lamp in Tight Fit Kit needs to be replaced every two years.
Note:
UV lamps will continue to emit visible light but lose germicidal effectiveness over time.
1.
Remove O-rings. Remove lamp from lamp clips one side at a time.
2.
Replace with new lamp and snap lamp into clips on each side. Reinstall O-rings.
2
Power Supply Installation
IMPORTANT!
Check which power supply
is included with your Tight Fit Kit before
connecting to power. Turn off main power
source before installation.
1.
Find a suitable location for the power supply
inside the control panel of the air handler.
Install using the self-tapping screws and/or
the double sided tape.
2.
Use the wiring diagrams below to connect to
power. The low-voltage power supply (18 thru
32 VAC) is marked "ER". The line-voltage (110
thru 277 VAC) power supply is marked "ST".
Heating Element Caution!
IMPORTANT!
The Tight Fit Kit’s components are designed to withstand the typical
ambient temperatures found near fan coil and PTAC heating elements up to a constant
194°F (90°C). If installing the lamp near a heating element, secure the wires as far
away from the heating elements’ wires as possible to prevent them from touching the
element. In addition, use the included split-loom tubing for additional protection of
the power supply wires that may be mounted near the heating elements.
Line-voltage
"ST"
wiring
2.
1.
Align Flanges
3
UV Lamp Connection
1.
When all the other components are properly installed connect the UV lamp
cable to the power supply cable.
2.
Make sure the flanges are aligned and then push the connectors firmly
together. A tight connection ensures a proper water-resistant seal.
2.
1.
"ER"
18 thru 32 VAC Power
Supply
"ST"
110 thru 277 VAC Power Supply
IMPORTANT! Must be wired to constant power - do not connect to blower relay.
Note:
Use of replacement UV lamps other than Fresh-Aire UV® voids warranty
.
Caution:
UV lamps contain small amounts of mercury - dispose of lamps in accordance
with local environmental regulations. For more information visit www.lamprecycle.org
TUVCL-215P
AIR HANDLER
24 VAC
TRANSFORMER
24 VAC
POWER SUPPLY
UV LAMP
BLUE CABLE
BLACK
RED
Low-voltage
"ER"
wiring
18 thru 32 VAC TRANSFORMER
COMMON / BLUE
HOT / RED
Manufacturer’s Warranty:
This warranty supersedes and replaces any warranty statements orally made by the Sales Person, Distributor or Dealer or contained in the written instructions or other
Brochures or informational documents in relation to this product. This warranty gives you specific legal rights, and you may also have other rights which vary from
State to State.
What Does This Warranty Cover?
This lifetime limited manufacturer warranty covers any defects or malfunctions in material and workmanship under the normal use
and service when operated and maintained in strict accordance with manufacturer’s instructions for the Lifetime of the equipment.
How Long Does The Coverage Last?
1) Power Supply: For as long as you own the real property where the product is installed. 2) TUVL-215P Series Ultraviolet Lamp
is warranted for germicidal output for two years from the date of installation. This warranty is not transferable.
What Will Triatomic Environmental, Inc. Do?
Triatomic Environmental, Inc. will replace any defective or malfunctioning part at no charge. You must pay any labor
charges and shipping charges of defective product to our warranty department.
What Does This Warranty Not Cover?
THIS PRODUCT IS NOT INTENDED TO BE PURCHASED AND INSTALLED BY UNLICENSED HVAC OR ELECTRICAL CONTRACTORS. This
warranty does not cover products or parts purchased from any source other than licensed HVAC or electrical contractors. This warranty does not cover parts installed
by unlicensed HVAC or electrical contractors. This warranty does not cover parts damaged as a result of misuse, abuse, or any use other than its intended use, accident,
acts of god, neglect, or from improper operation, maintenance, installation, modification or adjustments. Triatomic Environmental, Inc. shall have no responsibility for
charges incurred by the customer for installation or removal of warranted items.
This warranty does not cover parts or equipment used with the Fresh-Aire UV system that are not manufactured by Triatomic Environmental, Inc.
**This warranty shall be void if UV lamps from manufacturer’s other than Triatomic Environmental, Inc. are used with this equipment.
Consequential and incidental damages are not recoverable under this warranty. Manufacturer assumes no liability for any harm, which may occur as a result of the use of
the equipment herein and shall not be liable for consequential or any other damages whether or not caused by manufacturer’s negligence or resulting from any express
or implied warranty or breach thereof. Consequential damages for the purpose of this warranty shall include, but not be limited to, loss of use, income or profit, or loss
of or damages to property or injury or death to persons or animals occasioned by or arising out of operation, use, the operation, installation, repair or replacement of
the equipment or otherwise. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not
apply to you. There are no Warranties which extend beyond the description of the face hereof.
How Do You Get Service?
In order to be eligible for service under this warranty you MUST return the warranty registration card or register online at www.freshaireuv.
com. If something is wrong with your product, call your installing contractor to receive a Return Merchandise Authorization (RMA) and instructions for returning the
product to a licensed distributor in your area or the manufacturer.
Once the product is returned, we will inspect your product and contact you within 10 business days of our receipt of the product to give the results of our inspection. If
we determine that the product is covered under this warranty, we will ship to you at no additional cost a replacement part. Replacement parts may be refurbished. If we
determine that the product is not covered under this warranty, or that this warranty is void, the product will be returned to you COD. There is no charge for inspection.
How Does State Law Apply?
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
5
Sight Glass Installation (Optional)
Sight glass may not be needed if reflected
UV light is visible.
1.
Find a suitable location on the outside of the unit
near the UV lamp installation and apply the Fresh-
Aire UV® warning/lamp replacement sticker.
2.
Drill a ½” hole through the outer case on the unit.
Press the UV safety viewport into hole.
3.
Turn on the power and use the sight glass to confirm
that the UV lamp is operating.
PIG TAIL
PIG TAIL
110 tru 277 VAC
Double Sided Mounting Tape
18 thru 32 VAC
