APCO MAG 15
APCO MAG 11
APCO MAG is usually installed inside the central
air handling system. Orient so the air flows past
the UV light first before the carbon. Position the
unit so the UV light does not shine directly on non-
uv-resistant materials (filters, humidifiers, flex duct,
etc.). Ideally the UV light shines on the coil.
For dual systems select a remote UV light location
that shines on the greatest surface area or the
area with the most microbial growth. Refer to the
Optional Remote UV Light section for installation
instructions.
Typical Installation Locations
Air Handler
2nd UV Lamp
Package Unit
APCO MAG Installation
APCO MAG Parts List
A
Main Unit
Small Parts
E
Self-tapping Screws
G
Tap-in Connector
H
Quick Nut (plastic)
I
Spade Connector
Optional 2nd UV Light (Dual)
V
PART:
TUVL-115P
LIFE:
1 Year
W
PART:
TUVL-215P
LIFE:
2 Year
X
WARNING
Panelsticker
Y
WARNING
Sight Glass
Z
Magnet mount
Power Supply
N
ER Power Supply
O
ST Power Supply
P
SI/DI Power Supply
MAG15 UV Lamps
J
PART: TUVL-115 LIFE: 1 Year
K
PART: TUVL-215 LIFE: 2 Year
MAG11 UV Lamps
L
PART: TUVL-111 LIFE: 1 Year
M
PART: TUVL-211 LIFE: 2 Year
H
1. Determine the optimal position for
placement of MAG unit inside the air
system.
2. Use a utility knife to cut a slit in the
insulation on the interior surface.
3. Place the magnetic mounting bracket
directly on the metal surface or remove
the magnet and hard-mount the
bracket using the self-tapping screws
provided. Use foil tape to close the cut
in the insulation.
4. Mount the UV Lamp to the MAG unit as
shown using 2 quick nuts.
5. Connect lamp: make sure the flanges
are aligned and then push the
connectors firmly together. A tight
connection ensures a proper water-
resistant seal.
3.
4.
5.
Important!
do not install the mounting
magnet within 12” of digital signal devices
as this may cause interference.
STEP 1: APCO MAG Surface Installation
Align Flanges
2.
STEP 2: Connecting APCO MAG to Power
IMPORTANT
Before connecting to power confirm which APCO MAG model is being installed. Turn off main
power source before installation. Model information is printed on the Power Unit cover.
IMPORTANT! Must be wired to constant power - do not connect to blower relay.
APCOMAG ER
APCOMAG
SI/DI
ST/DT
120-277 VAC
POWER SUPPLY
UV LAMP
4 PIN
CONNECTOR
L1 - BLACK
L2 or N - WHITE
GND - GREEN
Optional 2nd UV Lamp
24 VAC
POWER SUPPLY
UV LAMP
BLACK
4 PIN
CONNECTOR
RED
24 VAC TRANSFORMER
COMMON / BLUE
HOT / RED
