16
Safety lock function
：
In any state, pull off the safety lock can be emergency stop the operation of the
treadmill,when treadmill emergency stop, will hear a long buzzing ,window
display“safe”.At this time,the treadmill can not do any operate except shutdown.After
correct installation of the safety lock,treadmill back into the standby state,waiting for a
command input.
Turn Off
The treadmill can be turned off by shutting down the power switch at any time, it wont be
damaged.
Adjustment Instructions
1.
Before the supply Make sure that voltage is normal, make sure the ground line is
good, use hands to promote the running belt if it is flexible operation, with or without
abnormal noise, resistance work good.
2.
Turn on the power, turn the red power switch on the front end of the treadmill,
electronic table display after three seconds into the standby mode, press the "Start /
Pause" button, the treadmill running, running speed is 1km / h, then please observe the
running ministries machine is working properly.
3.
Press all buttons on electronic form, to see if each of its labeled function keys
corresponding to the key is valid and feel is good.
4.
Press the safety switch, observe whether the electronic table matrix screen and
the time window will display (Emergency Action) prompt characters. Whether the running
treadmill stops.
5.
Use hands to shake the machine armrest, confirm the whole machine is stable.
6.
Tightness in commissioning the machine running belt, see "treadmill routine
maintenance."
Daily maintenance:
The electric treadmill adopts special imported running belt, which is made of
special production technology of cotton composite material. It has the advantages of
small friction coefficient, high tensile strength and low noise. The running board adopts a
unique double damping system. The top layer of urea-formaldehyde resin has high
surface finish and super wear resistance, making the movement more comfortable and
smooth!
1. When the machine has a lot of dirt or the lubricant is reduced, the friction
coefficient of the running board and the running belt will increase, and the load output
power will increase. As a result, the running board may be caused and the running belt
surface is severely worn. (Motor, inverter, roller, motor belt, etc.) The entire drive system
is seriously damaged. This damage is not covered by the warranty.
2. At least one inspection of the running condition of the running board and the
running belt must be carried out every week. Please increase the oil according to the
actual frequency of the treadmill of the fitness club. (If the frequency of each machine is 6
hours or more per day, add oil every 10 days or so, each time is increased by about
50ml each time. If the
MACHI NE DEBUGGI NG PROCESS
