17
frequency of each machine is less than 6 hours per day, every 15 days Add oil to the left
and right, each time adding about 50ml each time.
Remember: Do not use oil excessively. It’s not right that he more lubricant, the better.
Reasonable lubrication is an important factor to improve the service life of the treadmill.
3. Lubricating oil increase method:
●
Use oil cans and tubing to add lubricating oil from both sides of the running
belt to the standing area of the user's feet;
●
Start the treadmill, the treadmill runs slowly at a speed of 1KM/, and the user
walks on the running belt so that the lubricating oil can be evenly spread on the
running belt.
Remember:
●
Do not use lubricant excessively. The more lubricant, the better.
Reasonable lubrication is an important factor to improve the service life of the
treadmill.
●
Be sure to run at low speed after adding lubricating oil, avoid running the belt
to break the lubricating oil into the motor during high-speed operation, causing the
motor to short-circuit and damage the motor;
4. Determine the amount of friction:
Uncleanness or reduced lubricant can cause increased friction between the running
board and the running belt, and may cause damage to the motor and the inverter. The
friction is too large and has the following characteristics:
(1)
In the power-off state, using the foot to move the running belt, it feels
very difficult, even unable to move.
(2)
The treadmill is unloaded normally, and the speed is obviously slow or
irregularly stopped during load.
(3)
The frictional force increases, which may cause wear of the running belt,
the motor control board is damaged, the overload protector operates, and the inverter
protects.
5. Running belt deviation adjustment:
The treadmill should be adjusted before and after the installation. After using for a
period of time, the running belt may run off. The reasons for this phenomenon are as
follows:
(1)
The main unit is not placed smoothly.
(2)
When the user is exercising, the feet are not in the center area of the running belt.
6. The phenomenon of deviation caused by man-made can resume normal after two
to three minutes of no-load operation. For the deviation phenomenon that cannot be
automatically recovered, apply the special tool (M8L type wrench) that is equipped with
the adjustment screw in the rear screw hole in units of a quarter turn (ninety degrees).
7. Specific adjustment method: If the running belt is biased to the left, adjust the
adjusting screw on the left clockwise or adjust the adjusting screw on the right
counterclockwise. If the running belt is biased to the right, adjust the adjusting screw on
the right or counterclockwise. Adjust the adjustment screw on the left and recommend
adjusting it to ninety degrees (one quarter turn) each time.
The running belt deviation is not covered by the warranty. It is mainly maintained by
the user. The running belt will seriously damage the running belt. It must be discovered in
time and corrected in time
8. The overall elastic adjustment method of the running belt: If the running belt is
loose overall, the user may have “slip phenomenon during running, or the running belt is
too tight
