freightliner PE116DC, Руководство по обслуживанию

Страница: 108 / 164

NOTE: Meritor RPL35 driveshafts are not ser-
viceable. If the U-joint is worn, replace the drive-
shaft assembly.
4. Check U-joint assemblies for wear by moving the
driveshaft up and down, and from side to side. If
any movement of the U-joint cross in the bear-
ings can be felt or seen, replace the U-joint as-
sembly.
5. Check if the midship bearing and mounting are
loose or have deteriorated, by attempting to
move the driveshaft up and down, and from side
to side. If the bearing is loose on its shaft, or
rattles, replace it. If the bearing mount is loose
on the frame, tighten the mounting fasteners to
the proper torque value. See
Group 41 of the
New Cascadia ™ Workshop Manual for torque
specifications. Replace the midship bearing as-
sembly if the rubber cushion is deteriorated or
oil-soaked.
6. Check slip joints for spline wear by moving the
sleeve-yoke and splined shaft back and forth.
See
Fig. 5 . If the slip joint can be twisted in a
clockwise, or counterclockwise movement
f410067b 10/06/2016
1
2
3
3
4
5
6
7
8
9
10
11
12
13
14 15
16
NOTE: Not all fasteners are shown.
1. Transmission
2. Transmission Output-Shaft
End-Yoke (yoke-strap type)
3. U-Joint Assembly
4. Bearing Cap Self-Locking
Capscrew
5. Bearing Cap
6. U-Joint Cross
7. Bearing Cup (for yoke strap)
8. Yoke Strap and Capscrew
9. Slip-Joint Assembly
10. Sleeve-Yoke (bearing-cap type)
11. Dust Cap
12. Splined Stub Shaft
13. Driveshaft Tube
14. Tube-Yoke (bearing-cap type)
15. Axle Input-Shaft End-Yoke
(yoke-strap type)
16. Rear Axle
Fig. 3, Components of a Basic Driveline
Driveline
41
New Cascadia Maintenance Manual, January 2017
41/2