freightliner PE116DC, Руководство по обслуживанию

Страница: 132 / 164

MAX HOT lines. See Fig. 1 . See Table 1 for ap-
proved power steering fluids.
Approved Power Steering Fluids
Fluid Type Approved Fluid
Automatic Transmission Fluid
Dexron® III
Super ATF
TES-389
Table 1, Approved Power Steering Fluids
12. Apply a thin film of power steering fluid on the
gasket of the new filter, then attach the filter to
the filter cap and install the cap on the reservoir.
•
For filter caps with a separate retaining
ring, hand-tighten the filter, then turn it an
additional 1/4 turn.
•
For one-piece filter caps, the filter is not
threaded.
13. With the engine off, turn the steering wheel from
full left to full right three times. Add more power
steering fluid as needed.
14. Start the engine and operate the engine at idle.
Check that the power steering fluid level is be-
tween the MIN COLD and MAX HOT lines. Add
more power steering fluid if needed.
15. Turn the steering wheel from full left to full right
several times. Add fluid to the reservoir as
needed to maintain the fluid level between the
MIN COLD and MAX HOT lines.
16. Shut down the engine.
17. Raise the vehicle, remove the jack stands, and
lower the vehicle.
46–03 Power Steering Gear
Lubrication
NOTICE
Apply grease to the sector shaft with a hand-type
grease gun only. Use of a high-pressure power
grease gun will supply grease too quickly and
could affect the high pressure seal, contaminating
the hydraulic fluid.
Using a hand-type grease gun, apply NLGI Grade 2
or 3 multipurpose chassis grease until it starts to
come out past the sector shaft seal. See
Fig. 2 .
46–04 Drag Link Lubrication
1. Park the vehicle on a level surface, shut down
the engine, and set the parking brake. Chock the
tires.
f462253a 02/17/2017
1
2
4
3
1. Reservoir
2. Filter Cap
3. Pressure Line
4. Return Hose
Fig. 1, Power Steering Reservoir
f461071 10/07/2016
1
1. Sector Shaft Grease Fitting
Fig. 2, Steering Gear Lubrication
Steering
46
New Cascadia Maintenance Manual, August 2019
46/2