Freggia CHCT, Руководство пользователя

Страница: 13 / 36

GB
13
COMMANDS
13
REPLACING LED LIGHTS
(FIG.6)
If the appliance version is with LED lamps, the intervention of a specialized technician is necessary to replace them.
Attention!
In doing this operation, please take care not to scratch the hood.
Attention!
Replace the bulbs with new ones of the same type.
COMMANDS
A = AUTOMATIC STOP TIMER (15 minutes)
B = SPEED III
C = SPEED II
D = SPEED I
E = OFF
F = LIGHT
To acivate the
INTENSIVE
speed function, press key
B
for two seconds and it will be activated for 10 minutes after
which it will return to the previously set speed. When the function is active the LED flashes. To interrupt it before the
10 minutes have expired press key
B
again.
By pressing key A for two seconds (with the hood switched off) the CLEAN AIR function is activated. This function
switches the appliance on for ten minutes every hour at the first speed. As soon as this function is activated, the motor
starts up at the first speed for ten minutes. During this time, key A and key D must flash at the same time. After ten
minutes the motor switches off and the LED of key
A
remains switched on with a fixed light until the motor starts up
again at the first speed after fifty minutes and keys A and D start to flash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e.g.
if key
C
is pressed the
CLEAN AIR
function is deactivated and the motor moves to the second speed straight away. By
pressing key E the function is deactivated).
The
AUTOMATIC STOP TIMER
delays stopping of the hood, which will continue functioning for 15 minutes at the
operating speed set at the time this function is activated.
ANTI-GREASE/ACTIVE CHARCOAL FILTERS SATURATION
When the
F
key flashes with a 2-second frequency, the antigrease filters must be washed.
When the F key flashes with a 0.5-second frequency, the active carbon filters must be replaced or washed depending
on the type of filter.
Once the clean filter has been put back one must reset the electronic memory by pressing the
F
key for approximately
5 seconds until it stops flashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING
THE ABOVE WARNINGS.
USE AND MAINTENANCE