FreeWave Technologies
900 MHz High Throughput Wireless Ethernet Modem/
Terminal Server (model HTP-900XX) Installation Guide
v. 1.0c
LIG0007AA V1.0 RevC
3 of 8
FCC Notification
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) This device may not cause harmful
interference and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This device must be operated as supplied by FreeWave Technologies, Inc.
Any changes or modifications made to the device without the express written
approval of FreeWave Technologies may void the user's authority to operate
the device.
CAUTION:
This device has a maximum transmitted output power of 871mW
(29.4 dBm). It is required that the transmit antenna be kept at least
23 cm away from nearby persons to satisfy FCC RF exposure
requirements.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and may radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
♦
Reorient or relocate the receiving antenna.
♦
Increase the separation between the equipment and receiver.
♦
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
♦
Consult the dealer or an experienced radio/TV technician for help.
Note:
Whenever any FreeWave Technologies module is placed inside an enclosure a label
must
be placed on the outside of that enclosure which includes the module's FCC ID.
