BATTERIES & BATTERY CHARGING
BATTERY INSTALLATION
Your scooter is equipped with two maintenance free 12 volt batteries. The batteries are linked
together by wiring cables to supply the electronic system with 24 volts of power.
When first installing the batteries follow these assembly instructions:
1. Connect the red wire of the battery cable to the + inal of the battery, with then nut and washer
provided.
2. Connect the black wire of the battery cable to the negative terminal of the battery, with the nut
and washer provided.
3. Repeat this procedure on the second battery making certain the red/black terminal covers are
secured over each terminal.
4. Position each battery onto the scooter frame.
5. Secure the two batteries into position with
the clamp bracket, "J" bolt and wing nut
supplied.
Note: The "J" bolt hooks into an 8mm hole
situated in the seat post support bracket.
6. Connect the two grey plugs of the batteries into the two
grey sockets of the wiring circuit.
7. Switch on your Scooter, the battery meter
will now illuminate to show the state of
charge in the batteries and your scooter is ready to drive.
32
Warning:
It is imperative that the two batteries are connected correctly to prevent a
short circuit between the two batteries.
!
Caution:
Batteries are heavy you may require assistance.
8. Switch off your scooter, fit the battery
cover and seat.
1
2
3
Содержание 510GDX
Страница 44: ...28 ...