9
11.
Make sure that all parts are properly tightened before you use the exercise bike.
Note: After assembly
is completed, some extra parts may be left over.
9
9. Place the exercise bike in the location where it
will be used.
Tip: Place a mat beneath the
exercise bike to protect the floor.
Make sure that all four Leveling Feet (47) are in
contact with the floor.
If a Leveling Foot (47) is not in contact with the
floor, loosen the Leveling Foot until the Leveling
Foot contacts the floor.
Then, tighten the Hex Nut (46) on the Leveling
Foot (47) firmly against the Rear or Front
Stabilizer (11, 12).
Tip: It may be helpful to
use an adjustable wrench to tighten the Hex
Nut.
10
10. Loosen the Resistance Knob (34) until the
Brake Pads (66, 67) are
not
in contact with the
Flywheel (54).
Spray the Brake Pads (66, 67) thoroughly with a
clear silicone lubricant (not included).
Note: This action will extend the life of the
Brake Pads (66, 67) and ensure smooth contact
with the Flywheel (54).
Then, tighten the Resistance Knob (34) until the
Brake Pads (66, 67) are in firm contact with the
Flywheel (54). Leave the Brake Pads in this
position for one hour or longer.
Note: This action will set the brake parts and
provide the springs with initial compression.
This action will also ensure that the clear sili-
cone lubricant penetrates the entire surface of
the Brake Pads (66, 67).
46
47
11
12
46
46
47
34
66
67
54
47
8
8. Attach a Water Bottle Holder (8) to one side of
the Frame (1) with two M5 x 16mm Screws (7).
Attach the other Water Bottle Holder (8) to
the other side of the Frame (1) in the same
way.
7
7. Identify the Left Pedal (75), which is marked
with an “L.”
Using an adjustable wrench,
firmly tighten
the
Left Pedal (75)
counterclockwise
into the Left
Crank Arm (52).
Tighten the Right Pedal (6)
clockwise
into the
Right Crank Arm (14).
6
75
8
1
8
7
7
52
14
8
