7
3.
IMPORTANT: During steps 3–7, set the parts
that you remove in separate piles. You will
reattach the parts in later steps.
Remove the six M6 x 10mm Screws (59), the six
M6 Large Washers (74), and the Access Cover
(41) from the Tower (1).
74
59
41
1
3
59
74
59
74
74
59
59
74
59
74
2.
Tip: It may be helpful to adjust the height
of the Platform (3) to do this step (see
ADJUSTING THE PLATFORM on page 14).
Insert the free end of the Resistance Cylinder
(18) into the tab underneath the Platform (3).
Then, tighten an M8 Locknut (77) with an M8
Washer (71) onto the Resistance Cylinder.
3
71
Tab
2
77
18
