Freeman PF20LM, Руководство пользователя

Страница: 4 / 25

06
MODEL: PF20LM MODEL: PF20LM
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672 HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
FEATURES
SPECIFICATIONS
OPERATION PRESSURE:
MAGAZINE CAPACITY:
TOOL WEIGHT:
AIR INLET:
: FASTENERS RANGE
70-115 psi
120 pcs
8.25 lbs
1/4”NPT
1 to 1-1/2”
Compatible with generic 20 gauge
L
cleats.
FEATURES
ERGONOMICALLY DESIGNED HANDLE
For ease of operation and reduced fatigue.
NO-MAR DESIGN
Provides increased protection from marring
when working with a finished flooring
surface.
ANODIZED ALUMINUM MAGAZINE
For long lasting durability.
DURABLE CONSTRUCTION
Light weight and durably constructed of
high-strength aluminum and heat treated
steel parts.
FIBERGLASS MALLET WITH RUBBER
HEAD INCLUDED
●
●
●
●
●
OPERATION
LOADING L CLEATS
Connect the tool to the air source.
Insert strip of fasteners from the rear of
magazine(D). Be sure the fasteners are
pointed downward. (See figure 1 & figure 2)
This tool uses a spring loaded bypass lever
in order to load and upload the nails. Once
the nails are properly inserted, pull the
pusher(E) completely back, pressing
against the bypass lever (F) of the pusher.
(See figure 3)
Once the pusher hits the back of magazine,
allow the pusher to slide forward and
engage the nails, pushing them to the nose
of the tool. (See figure 4) 1.
2.
3.
4.
07
The tool is shipped with the Arm part (A)
detached from the main body part.
Follow these instructions to prepare the tool for
use.
Set the Arm(A) against the Handle .
Wrench-tighten the Nuts(B) until the Arm(A)
and Handle (C) are secured and the Arm(A)
is locked against Handle(C).
PREPARE THE TOOL
1.
2.
Nut (B)
Hex. Bolt
Handle (C)
Arm(A)
Prepared
Flooring Nailer
Rear of magazine(D)
IN
SE
RT
N
AI
L
ST
RI
P
Figure 1
Figure 2
Pusher(E)
Bypass lever ( F )
SLID
E FO
RW
ARD
Figure 3
SLIDE
BACK
Engage Nails
Figure 4
SLID
E FO
RW
ARD
The tool may fire when it is first
connected to the air source. Always
connect the tool to the air source before
loading fasteners to prevent injury from
unintended cycling. Always make sure the
tool’s magazine is empty at the beginning
of each work session, before connecting
to an air source.
Only use those fasteners recommended
for use with this tool. Fasteners not
identified for use with this tool by the tool
manufacturer are able to result in a risk of
injury to persons or tool damage when
used in this tool.
25mm
32mm
38mm
1”
1-1/4”
1-1/2”
0.193”(4.9mm)
25mm
32mm
38mm
1”
1-1/4”
1-1/2”
0.252”(6.4mm)
(20 Ga.) (20 Ga.)