HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
10
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
11
FIGURE 7
2.
Tighten both adjustment plates by 1 or 2 holes (Fig.
7). The adjustment on both plates must be the
same.
HONING BLADE
Removing burrs from the flat edge of the blade is very
important, honing a new blade should be done after
the first 40-100 cuts, after every 100+ cuts and when
the blade has been re-sharpened.
With the blade (Fig. 10-B) installed and positioned
roughly 1/8” above the table top, lay the flat side of
your honing stone (Fig. 10-A) against the flat side of
the blade. Move the honing stone from one end to the
other a few times until burr has been removed.
FIGURE 10
SHARPENING OR REPLACING BLADE
A
B
The included blade can be sharpened. Only the
beveled edge of the blade must be sharpened. The
WARNING:
Blade is very sharp. Wear gloves when
handling blade.
1.
To remove the blade (Fig. 8-A), remove the seven
allen head screws (Fig. 8-B) using the supplied
hex. key. Carefully remove the blade.
2.
Once blade has been sharpened or replaced, it can
be re-installed. Position the blade (Fig. 9-A) with its
flat edge facing the table (Fig. 9-B). Make sure
the mounting surface and blade are clean,
re-install the blade with the seven allen head
screws removed earlier using the supplied hex key.
flat edge of the blade must remain flat. We
recommend that this operation be done by a qualified
professional.
FIGURE 8
FIGURE 9
LUBRICATION
To prevent surface corrosion, it is recommended to
apply a small amount of light machine oil on the
sliding parts of the laminate cutter. Lubrication should
be done once every two months or once a month if
working in dirty or dusty conditions.
WARNING:
Do not completely loosen or remove the
adjustment plates. Adjustment plates are
under high spring tension.
MODEL: P13INLC
MODEL: P13INLC
Содержание P13INLC
Страница 23: ......