16
clockwise. Once the unit has been unlocked, it can be pulled out further to allow the monitor to
lean back further. Be sure to return the unit to its original state and lock the unit by screwing the
two screws after use to prevent damage.
3.7 Testing the Drawer
To test that the drawer is working properly, perform the following steps:
1. Power up the monitor/keyboard drawer, and then turn on your computer.
2. Make sure the video image is centered within the screen area. Use the OSD controls to
adjust the image (see note below) or press the Auto button on the right hand side of the
monitor.
NOTE: If the unit does not power up when the panel is pulled up, try pushing the soft power
on/off button on the left side of the monitor panel to power up the unit. You can adjust the
horizontal and vertical position, contrast, and brightness to better suit your video card and your
personal preference. Refer to Section 2 for more information on using the on-screen menu to
adjust the video display. Before you begin, make sure that power to all the devices you will be
connecting up have been turned off. To prevent damage to your installation due to ground
potential difference, make sure that all the devices on the installation are properly grounded.
Consult your supplier for any technical issues if necessary.