10/15
9/15
7. System Connection
7.1 System Connection
Optical Unit (MOTOR interface)------- Motorized bracket
（
Motor driving signal interface
）
Optical Unit (SYNC interface) --------- Digital Projector (GPI / O or 3D Interface )
Optical Unit (POWER interface) ------- Power Adapter (24V 3.75A input)
Figure 7-1 System Connection
7.2 LED status indicators
After the connection is completed, turn on the system and digital projector
to play 3D movie, check the cables are connected correctly by observing
the LED status indicators on the front panel, as shown in
Figure 7-2.
Figure 7-2 LED Status Indicators
POWER indicator:
when illuminate green, status ok. When off, check the power cord is
connected properly.
SYNC indicator:
When illuminated green, 3D signal is detected. When off, not detected,
check the 3D sync cable is connected properly and the projector is set
correctly.
L / R indicator:
When illuminated green, L/R polarity signal is detected. Press L / R button
to switch left/right picture if the screen image is not correct.
SYNC
POWER
ON/OFF
L/R
L/R
POWER
MOTOR
SYNC
SYNC indicator
L/R Signal Indicator LED
Power indicator
Turn on the system and digital projector to
play 3D movie, check the LED status indicator
L/R Polarity Switch
Power Switch
3
or
2
1
SYNC
POWER
ON/OFF
L/R
L/R
POWER
MOTOR
SYNC
Power Switch
Power Input Interface
SYNC Interface
L/R Polarity Switch
Motor driving signal Interface
Connect motor driving
signal cable
M o t o r d r i v i n g
signal Interface
Connect SYNC
GPI/O Interface
(37pin )
Connect digital
rojector
Connect power cord
100~240V AC Power Input
24V 3.75A Power Output
3D Interface
(15pin)
