Freecom Internal IDE, Руководство пользователя

Страница: 5 / 31

Cautions During Use
Don’t suddenly move the drive from a cold place to a warm one, or suddenly
raise the room temperature. Condensation may occur, causing abnormal
operation.
Be careful to prevent foreign objects such as liquids or metal from entering
I
Make sure to remove the disc before moving the drive. The disc may be
damaged, causing data loss.
the drive. Should by chance a foreign object enter the drive, please consult
the dealer where the drive was purchased.
Don’t use benzene or thinner to clean dirt from the drive. Don’t al-low
chemicalssuch as insecticides to contactthe drive. Use a soft cloth to wipe the
drive, or moisten a cloth with neutral detergent diluted with water and use
it to clean particularly dirty areas.
Don’t cutoff the electric power while the drive is operating.
Never insert a damaged disc into the drive.
In wintertime, don’t use a disc soon after bringing in from outdoors. Use
only after it has reached room temperature.
it
SCSI:
l
If two different devices with the same SCSI ID are connected to the SCSI bus,
the system may fail to function. Be careful that none of the SCSI are the
same when installing the equipment.
l
Keep the total length of the SCSI cable within 6 meters.
l
When connecting the SCSI cable to the drive, make sure the power is OFF.
IDE-ATAPI:
l
The total length of the IDE cable should be no more than 18 inches (about 45
cm).
l
Make sure the power to the host computer is turned OFF before connecting.
l
When connecting two IDE devices to the Primary or Secondary connectors,
make sure that the two devices are not both configured as Master, or both
as Slave. If they are both set the same, Windows may fail to run or
the drives.
Cautions Concerning Disc Cleaning
l
Remove the disc by pressing the eject button.
l
Use compressed air to clear dust from the drive. (Spray the compressed air for
about 5 seconds).
l
Check to see if there is dirt on the surface of the disc. Be careful not to touch
the disc with the fingers when doing this.
l
After cleaning the disc with compressed air, place it on the disc load
in the drive.
3