![background image](http://html.mh-extra.com/html/freecom/internal-ide/internal-ide_manual_2329623026.webp)
7.
the FREECOM CD-RW into the drive bay. Using all the screws included
in the bag to secure the CD-RW into the bay.
8.
Replace the cover.
Connect the
mains plug of your
configuration. When you
have successfully installed the drive and established all
connections, it is now
time to switch on the PC. You are ready to run the
and
then install
the software.
3. How to Use the Discs Before Asking for
Repairs
How to Use the Discs
Attantion! When using CD-ROM discs, CD-R discs or CD-RW
discs, don’t attach
any stickers or labels to the discs. Using discs with them attached
not only causes
read and write errors, but data on the disc may be lost due to damage to
the disc
itself.
Load the disc
1. Press the eject button.
2.
Place the disc on the disc tray.
Note! When using a 120mm CD, place it in the large round depression. The face
with the label on it should be up. Never place both discs in the tray at the same
time.
This drive (SCSI
ATAPI 4420) cannot be used with 80 mm CDs. Be
careful not to touch the recording surface of the disc.
3.
Load the disc by pressing the eject button or by lightly pushing in the disctray.
2. Disc ejection
1. Press the eject button.
2.
Slowly take the disc out of the disc tray.
3.
Press the eject button or push the disc tray and the tray will be brought back
into the drive.
After ejecting the disc, return the tray inside the unit quickly. When
the tray is
in the ejected position, dust and other debris will enter, possibly causing read
errors, write errors, or drive failure.
3. Emergency Eject
This drive has a function that allows the CD to be ejected manually if this
becomes necessary in an emergency such as failure of the drive or a power
outage. Follow the following procedures in such a case. Don’t use this feature
except in an emergency.
2 4
Содержание Internal IDE
Страница 1: ......